The dive suit may be wet or dry suit. The WET SUIT is made of 3, 5 or 7 mm neoprene and comes in either a two-piece design viz. Legging (Farmer John) and Jacket with attached hood closed by a convenient face zipper or a one-piece design. Wrist, ankle and face seals are watertight. On the other hand the DRY SUIT is made of 7mm neoprene or 1mm compressed neoprene (other material available). There is a separate hood for eliminating long preparation before the dive and special smooth 5 mm wrist and 3 mm roll neck seals in neoprene prevent water from seeping in or out. The watertight zipper runs along the back from elbow to elbow. The dry suits have an automatic/manual dumping system and a rapid inflation valve. The suit is supplied complete with a pair of five-fingered heat reflecting neoprene GLOVES. The suit is also supplied with a pair of BOOTS, which are comfortable & heat-reflecting with 5 mm neoprene lining, non-slip soles and nylon side zipper (these boots are incorporated / sealed in case of dry suits). FINS can also be supplied.

The Under Water Breathing Apparatus Set is supplied complete with a FULL FACE MASK designed for underwater utilization for emergency, commercial & technical uses. The mask has a wide-view vision visor and the shape allows even for use of spectacles for the wearer. The visor is made of transparent polycarbonate with the optical part wider and closer to the face to maximize the visual field, particularly the peripheral area. The visor is scratch & impact resistant. The head harness has 6 straps – all directly attached to the face shield in a design that allows the pressure to be transmitted uniformly along the mask's skirt. Air circulation in the mask minimizes fogging of the lens and reduces the amount of CO and CO2 built up in the inhaled air. The face mask has an integrated second stage REGULATOR and connected to the 1st stage via a breather hose. The 1st stage regulator will have 4 LP and 2 HP ports and will come with DIN Fitting. The set will be supplied with a PRESSURE GAGE, which can be connected to the 1st stage of the regulator to check the pressure of air in the cylinders. The set will also include alloy steel DIVE TANK (Single or Twin Tank), which will have a water volume from 10 ltrs to 36 ltrs and is designed to operate to 200 Bar pressure (other tanks also available). The set will also include a BACK PLATE with adjustable reinforced soft rubber shoulder straps, quick-release buckles, tank harness that can be adjusted to hold the tank, and with non-slip internal support.